Siding Installation and Repair in Victoria, BC

Siding Installation and Repair in Victoria, BC — what to know

Victoria is wet. Rain sticks around. Shaded walls stay damp. If water gets trapped, you get mildew and rot. The goal is simple: keep water out and let walls dry.

We get that you just want it done right. No drama. No guesswork.

Moisture first

Every good job here starts behind the siding.
You need a water-resistive barrier. Think house wrap that actually sheds water.
Flash every opening: windows, doors, shelves, trim returns.
Add a rainscreen gap with furring strips. That little air space lets water drain and air move. Wet walls dry. Paint lasts longer.

Ventilation matters too. Attic and wall vents need to be clear. If moisture can’t leave, it sits and grows problems.

Siding options for Victoria homes

Fiber cement (Hardie plank or panel)
Tough in rain. Won’t rot or warp. Holds paint well. Fire resistant. Needs a rainscreen and stainless or hot-dip fasteners. Heavier to cut, but it lasts.

Cedar and other wood
Looks classic on character homes. Warm and natural. Needs steady upkeep. Keep it sealed. Clean the moss off the north side. Expect repaint or restain on a cycle.

Engineered wood (LP-type products)
Looks like cedar. Easier to handle than fiber cement. Edges and cut ends must be sealed. Good paint and maintenance make it a solid option.

Vinyl
Lower cost and simple care. Use a rainscreen and good trim details so water can drain. Can get brittle in cold and shows impacts.

Metal (steel or aluminum)
Zero rot. Low maintenance. Modern look. Needs insulation behind and careful detailing at seams. Higher cost up front.

What we fix most

Soft or rotten boards
Common near grade, under windows, and at trim bottoms. We pull bad pieces, check the sheathing, repair what’s wet, then replace and seal.

Leaks you can’t see from outside
Interior stains near windows or corners mean water is slipping behind the skin. Usually bad flashing or failed caulk. We open the spot, fix the source, and rebuild it right.

Moss and mildew
Shows up on shaded sides. We clean safely, improve drainage, and check the details that let water linger.

What makes a solid install here

• House wrap lapped and taped to spec
• Real rainscreen gap top and bottom
• Flashing that sheds over, never under
• Primed or sealed cuts before install
• Stainless or hot-dip nails/screws
• Clear vent paths so walls can breathe

Permits and local notes

• Re-siding often proceeds without a building permit, but new openings, structural changes, or heritage areas may need one
• Disposal follows CRD rules; Hartland for concrete, rubble, asbestos-safe handling if testing calls it
• We confirm with your municipality before we start

Materials and sourcing

We work with local suppliers like Slegg, LumberWorld, and RONA. Specialty products can come from the Mainland if needed. You do not have to pick the priciest option. We show where to spend and where to save.

Simple process

1. Quick call and a site visit. Photos help.
2. Clear scope and a line-by-line quote.
3. Site protection, demo, and disposal.
4. Flashing, wrap, rainscreen.
5. Siding install, trims, sealants, paint where needed.
6. Cleanup and walkthrough.

If your siding feels soft, shows green streaks, or just looks tired, send a few photos and your area. We’ll come by and tell you what it needs. Plain talk. Solid work. Victoria local.

‍